RPM Black Team Associated Pro2, SC10 & Trophy Rat Front Lower Suspension Arms

RPM started by increasing the amount of material surrounding the hinge pins. They then ditched the offset button head screws that prevent the hinge pins from sliding out. The new in-line screws are a tried and true method of improving strength simply by eliminating extra holes in the a-arms. Fewer holes means fewer places for cracks to start.  The support beams on our A-arms also gained some muscle. At their thickest, stock front a-arms are roughly 0.3” (7.62mm) thick. Rear a-arms are about 0.37” (9.4mm) at the thickest point, tapering down to 0.27” (6.86mm) at their thinnest. That amounts to a loss of nearly 30% of their thickness at the outer hinge pins! Not with RPM! These A-arms are a full 0.4” (10.16mm) thick over nearly their entire length! RPM only taper them slightly at the hinge pins to match the maximum size allowable of the hinge pin bosses. Additionally, the width of the a-arm support beams are beefier as well. All RPM A-arms are molded from our nearly indestructible blend of engineering grade nylons for performance you can trust. Compatibility