&nbspServos are powered by the ESC's output to the receiver. If you're using a higher-strength servo than the ESC can support (usually greater than 20kg), you may experience 'brown-outs' where the radio signal can be interrupted and cause erratic driving. This can be helped by plugging a Glitch Buster into the receiver smoothing the current delivery. However, in some cases, you may need to install an external BEC.

The D956WP has arrived! Based off the D954SW servo, this IP-67 rated version is the true waterproof, dust resistant upgrade for 1/10th-scale Rock Crawlers and Off-Road Trucks. As with our entire “D” line, this technologically-advanced servo is powered by our 32-bit MCU (Microcontroller Unit) and 12-bit ADC (Analog to Digital Converter) industrial science and possess Smart Sense engineering with rapid, high resolution response. The unprecedented programmability and wide-voltage capabilities deliver the most progressive, leading-edge performance for all your radio control needs. With incredibly durable steel gears, dual ball bearing and hardened steel output shaft, the high-end performing D956WP produces the mighty torque and reliability required to take bashers to the next level.

• Programmable PWM Digital Amplifier

• 32-Bit MCU with 12-Bit ADC Circuitry

• 4096 Resolution

• 1M Cycle Long Life Potentiometer

• Wide Operating Voltage (4.8 ~ 8.4 Volts DC)

• Dual Ball Bearing Supported Output Shaft

• 25-Tooth Output Spline

• Coreless Metal Brush Motors

• Nylon Reinforced Plastic Upper and Lower Case

• Diamond Cut Aluminum Heat Sink Center Case

• Water Resistant and Waterproof Proof Case

Programmable Functions*

• End Point Adjustments

• Direction

• Fail Safe

• Dead Band

• Speed (Slower)

• Soft Start Rate

• Overload Protection

• Data Save / Load

• Program Reset

• Total Height (A) = 46.5mm

• Body Width (B) = 40mm

• Below Mount (C) = 26.5mm

• Above Mount (D) = 14.5mm

• Total Length (E) = 53.2mm

• Total Width (F) = 20mm