Traxxas High-Torque Metal Gear Waterproof Brushless Red Servo
$189.34
Servos are powered by the ESC's output to the receiver. If you're using a higher-strength servo than the ESC can support (usually greater than 20kg), you may experience 'brown-outs' where the radio signal can be interrupted and cause erratic driving. This can be helped by plugging a Glitch Buster into the receiver smoothing the current delivery. However, in some cases, you may need to install an external BEC.
The Traxxas High-Torque 400 Red servo combines maximum steering authority with a long list of high-performance features. The servo utilizes full metal gears, dual ball bearings, and an aluminum center section for added heat dissipation. A cutting edge brushless motor provides 400 ounce-inches of torque for extreme applications.* The High-Torque 400 servo is fully waterproof, not just “water resistant” and drops into most 1/10 Traxxas vehicles for that perfect factory fit.
- Total Height (A) = 45mm
- Body Width (B) = 40.1mm
- Below Mount (C) = 27.4mm
- Above Mount (D) = 18.2mm
- Total Length (E) = 54.7mm
- Total Width (F) = 20.1mm
| Servo | |
|---|---|
| Size: | Standard |
| Sec/60 Degrees: | 0.15 |
| 6V Torque kg/cm: | 11.33 |
| Servo Spline Count: | 25tooth |
| Gear Material: | Metal |
| Waterproof Casing: | Yes |
| Signal Type: | |
| Drive Motor Type: | Brushless |
| Case Material: | Metal, Plastic |
| Rotational Degrees: | 120° (Normal) |
| Total Height: | 45mm |
| Body Length: | 40.1mm |
| Bottom to Under Mount: | 27.4mm |
| Top to Under Mount: | 18.2mm |
| Total Length: | 54.7mm |
| Total Width: | 20.1mm |
1 out of 5 stars
2 out of 5 stars
3 out of 5 stars
4 out of 5 stars
5 out of 5 stars
5 out of 5 stars
The best, without a doubt
