How to Make an RC Car Jump in Under 5 Minutes!

In this article (6)
The quickest DIY RC car ramp is a cardboard box cut in half diagonally. Mark a line from a top corner to the opposite bottom corner on two opposite sides, cut along both lines and across the top, and the box falls into two wedge-shaped jumps. It takes under five minutes and uses things you already have.
What you'll need
A sturdy cardboard box. I found one lying around that was 28 x 40 x 55 cm, but go smaller or larger to suit your RC car. The thicker the corrugated cardboard, the longer it lasts.
Packing tape, for reinforcing the ramp when the cardboard starts to tear or buckle.
A sharp utility knife or box cutter.
A marker pen.
Step 1: Mark out your box
With the marker, draw a diagonal line across one side of the box, from a top corner down to the opposite bottom corner. Do the same on the opposite side. The slope of that line is the slope of your ramp. A steeper line throws the car higher. A shallower one is better for distance. The shape of the box sets the slope, so stand a long box on its side for a gentler ramp or on its end for a steeper one.
Cutting on the diagonal gives you two jumps from one box.
Step 2: Make the cut
Cut carefully along the lines you marked. Cardboard is tougher than it looks and it's easy to slip, so cut away from your body and keep your fingers out of the blade's path. Once you've cut through both sides and the top, the box separates into two wedges.
Step 3: Test your new jump
Set the ramp on a flat surface such as a driveway or short grass, with clear ground to land on. Start slow. A good box often doesn't need any weight to keep it still, but if the car pushes the ramp along instead of launching off it, put a brick or a heavy rock inside the back of the wedge. Change the angle if you need to, and tape up weak spots as they appear.
How to control an RC car in the air
Once the car leaves the ramp you can still steer its pitch with the trigger.
Nose dropping? Give it throttle. The spinning wheels pull the nose up.
Nose pointing at the sky? Tap the brakes. Stopping the wheels drops the nose.
Landing: try to touch down with the chassis level, and ease off the throttle just before you land to spare the drivetrain a shock load.
Which RC cars are good for jumping?
Cars built for rough ground take jumps best: monster trucks, stadium trucks and buggies with long-travel suspension. Our monster truck guide names the ones we'd buy. Jumping loads the suspension, chassis and drivetrain, and a bad landing will break something sooner or later. When it does, look your model up in the Part Finder.
Related Products



