Pro-Line 1/10 Supersonic Speed Run Unpainted Body Shell

This is a Supersonic Speed Run Body for Slash® 4x4. Are you looking to convert your Slash® 4x4 into the ultimate Speed Run vehicle? Look no further than Pro-Line's all-new Supersonic body built from the ground-up to go fast and look good doing it! There is a whole community built around pushing the limits of speed with the Slash® 4x4 (and other SC-based trucks) and the Supersonic body will help you jump right in. Belted tires are a must for going fast and the Reaction HP SC tires and even the Avenger HP 1:8 tires pair perfectly with the Supersonic body! Make sure to get the Pro-Line Extended Body Mounts so you can slam the body as low as possible and wide offset hexes to add even more high-speed stability to your build and to fill out the wheel wells. Get your very own Supersonic Speed Run body today! They are going to go fast!

Supersonic setup shown with (all sold separately):

• Slash® 4x4 with Aluminum 17mm Wheel adaper set (TRA-6856X)
• Reaction HP SC BELTED tires (#10170-203)
• Raid 6x30 Removable Hex SC Wheels (#2785-03) using 2.8" 17mm Hex Adapers (#6336-00)

• Ultimate Slash® 4x4 Speed Run Body!
• Designed to Go Fast and Look Good Doing It
• Pairs Perfectly with Pro-Line’s Belted SC and 1:8 Street Tires
• Made with Crystal Clear Polycarbonate
• Use Pro-Line Extended Body Mounts to Get the Body Mounted Perfectly
• Add Wide Offset Hexes to Gain Stability and Fill Out the Wheel Wells
• Four steps to Speed Run Ready:

1. Clean Body and apply included window mask
2. Paint then peel the over-spray film off
3. Sticker your body (decal sheet included)
4. Mount your new body onto your truck

• Made in the USA

• Supersonic Speed Run Clear Body (1 pc)
• Window Masks
• Detailed Decal Sheets

• Length: 26.0" (660mm)
• Width at fenders: 12.7" (323mm)
• Height: 5.6" (142mm)
• Wheelbase: 12.8" (325mm)