Skip to content

Next Dispatch: 07h20m24s

Australia's Ultimate Hobby & RC Shop.

Save your Deans Ultra 'T' Connectors Using This Trick

How ToUpdated Angus1 min read

Save your Deans Ultra 'T' Connectors Using This Trick
In this article (5)

Deans plugs are great connectors and have been one of the most popular hobby connectors worldwide for a long time. Deans plugs can have quite a tight/firm fit, which causes a substantial amount of load/stress on the wires, especially for smaller wires.

A red Deans T plug soldered onto red and black battery wires

What You'll Need

A hot glue gun putting glue over the solder joints on the back of the Deans plug

Step 1

Apply hot glue - Don't over do it, the shrink wrap won't go over if there's too much hot glue.

Hot glue covering both solder joints, left to cool

Step 2

Wait a minute to allow the hot glue to cool.

Black heat shrink slid over the whole plug, flush with its front edge

Step 3

Slide the shrink wrap over the whole plug until it's flush with the end of the deans plug.

The heat shrink shrunk tight around the plug and both wires

Step 4

Heat with a heat gun, you should see the shrink wrap mould the hot glue inside, leaving a nice smooth finish.

Finished 👏

Never break your wires again! Pull as hard as you like :)

Share:
AngusHead of IT · Hobbies Direct

Related Products

Related Posts