Vanquish Silver Aluminium SCX10 II Rear Solid Currie F9 Portal Axle Differential/Axle Housing

Currie F9 Portal Rear Axle for SCX10-II based vehicles

The F9 Portal axles create extreme amounts of ground clearance under the center of your axle, increasing the clearance by 1/2"+ (13mm). This provides the equivalent of a tire over 1 inch taller than what is on your vehicle. The advantage of the Vanquish Currie F9 Portals is the gear reduction inside the portal (1.67:1) which can be adjusted with optional gear sets (1.4:1 Overdrive*). By adding reduction at the portal, less torque is transferred through the other upstream components in the drivetrain. These axles are a direct replacement to any Axial AR44 axle, using all stock links. 

These axles come with all parts needed to assemble a full rear axle. 

• Portal box integrated into the rear housing for the most clearance at the axle ends possible and a more scale appearance
  
• Gear reduction in the portal of 1.67:1 (18/30), Optional Overdrive Ratio* of 1.4:1 (20/28)
  
• Included Vanquish AR44 machined gear set
  
• Overall axle reduction of 6.26:1 with stock portal ratio
  
• 13mm increase in ground clearance
  
• Hex to hex width of 7.66 inches, only roughly 5mm wider than a stock AR44 axle with a narrow hex
  
• Chromoly inner rear axle shafts are triple bearing supported
  
• Chromoly stub shafts with 6mm design at the drive pin which tapers down to a 5mm thread for ultimate strength
  
• Chromoly spool
  
• Aluminum 12mm hex with set screw
  
• Uses all SCX10-II linkage
  
• Complete Fast Eddy Bearings kit
  
• Licensed by Currie Enterprises
  
• Comes with One Piece Bearing Retainers (Patent Pending)
  
• Double shear shock mounts
  
• Upper link mounts built into third member
  
• Increased upper link clearance for more suspension up travel ability
  
• Requires the use of a 350 SLW hub or greater on Vanquish 1.9 wheels, Incision wheels will require a #4 or greater. Other wheel manufacturers offsets will vary. Axles must be used in pairs, you cannot run a front portal axle without a rear and vice versa.
  

*Overdrive gear sets are recommended for use in the front axle only